Tools needed:  
    10mm 1/4 drive socket, wrench and extension. plastic pry tools or equivalent.
    
    Caution: Be careful not to bend plastic dash parts when removing. Pry or pull
                  straight out to prevent breaking. Most parts will release from the dash
                  fairly easy, as the plastic clips are designed to allow removal and re-installation.
                  Plastic pry tools are recommended. Do not use a flat bladed screwdriver with
                  sharp edges as a pry tool. You can use a small putty knife also.

                 
                  Carefully remove the middle dash trim starting on the right side. Once you
                  get the trim piece partially released, work both ways, pulling straight out
                  to remove panel.

                 
                  Squeeze the plug on the wire harness to release it from the trim panel.

                    
                     Unscrew the shift handle counter clockwise to remove.  Use your fingers to
                 carefully pry up the shifter cover starting from the bottom.

                    
                     Lift the cover over the handle, and let dangle on the left side of the dash, out
                 of the way, or you can disconnect the plug on the back and set aside.

                   
                    Using your fingers, pull straight out on the climate control and carefully wiggle
                the unit, pulling towards you until the clips release.
 

                   
                    Unclip the harness from the back of the climate control, and set aside. Be careful
                when handling the dash trim parts so they don't get scratched or damaged.

                  
                   Remove the (4) 10mm screws, (2 each side that secure the radio head unit)
               use a 1/4 drive socket, not power tools to remove. Be careful not to let the
               2 screws toward the back fall down inside the dash area when removing.

                  
                  

                  
                   Carefully pull the radio head unit out towards you to release it from the dash
                after removing the (4) 10mm screws.

               
                Remove wire harness from back of factory radio by carefully squeezing the clips
                until they release, DO NOT PULL ON THE WIRES!  Remove antenna, etc., and take
                head unit to work table to Remove and replace the A/C vents and radio side brackets.
               
               

               
                Remove the screws hold the A/C trim plate to the factory radio.

               

               

               
                Remove (4) screws from each side of radio to remove factory brackets which will be reused
                on the new Nav head unit.

               
                Reinstall factory brackets on new Navigation head unit.

               

               
                Attach A/C shroud onto to aftermarket head unit.

                  
               Pull out glove box by bending the back of the glove box toward you so you can release the tab
               on each side of the glove box, allowing it to swivel out of the way so the white iPOD cable can
               be routed from the Nav head unit opening to the glove box. After removing the glove box door,
               remove the philips screws holding the glove box in and remove.